Removing The Diskette Drive; Figure 7-5 Removing And Replacing The Diskette Drive - Sun Microsystems Sun Blade 1000 Service Manual

7.2.8

Removing the Diskette Drive

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the peripheral assembly on a flat surface so that the diskette drive is flat
(
FIGURE 7-2
2. Remove the smart card reader.
See Section 7.2.6, "Removing the Smart Card Reader" on page 7-7.
3. Using a No. 2 Phillips screwdriver, remove the four screws securing the diskette
drive to the peripheral assembly.
Note – The four screws that secure a drive to the peripheral drive assembly are
specifically sized screws. Do not intermingle them with other screws.
4. Remove the diskette drive and place it on an antistatic mat.
5. Install the filler panel if necessary.
Screw (4)
FIGURE 7-5
).
Removing and Replacing the Diskette Drive
Chapter 7 Removing and Replacing Storage Devices
Filler panel
Diskette drive
7-9