4. Replace the CPU shroud cover.
See Section 8.9.2, "Replacing the CPU Shroud" on page 8-41.
5. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6.4
Interlock Switch Assembly
Use the following procedures to remove and replace the interlock switch assembly.
6.4.1
Removing the Interlock Switch Assembly
1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Press the detent tabs at either side of the interlock switch assembly while pulling
the switch from the chassis switch housing (
3. Continue to press the detent tabs and pull the interlock switch assembly until the
interlock switch assembly is free from the housing.
4. Remove the combined cable assembly connectors from the interlock switch
terminators.
5. Remove the interlock switch assembly.
FIGURE 6-12
Chapter 6 Removing and Replacing Major Subassemblies
).
6-19