Replacing The Scsi Cable Assembly; Figure 6-7 Removing And Replacing The Scsi Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

SCSI cable assembly
FIGURE 6-7
6.3.4

Replacing the SCSI Cable Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Connect the SCSI cable assembly as follows (
a. Pass the SCSI cable assembly through the chassis cutout.
Route the SCSI cable assembly through the sheet metal cable guides.
b. Connect the SCSI cable assembly to connector J5002 on the motherboard.
c. Connect the SCSI cable assembly connector to the Tape or DVD-ROM drive.
2. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6-10 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Removing and Replacing the SCSI Cable Assembly
Chassis cutout
Connector J5002
Cable route
):
FIGURE 6-7