Firmware And Software Requirements For Installing Ultrasparc; Removing A Cpu Module; Table 8-1 Required Solaris Operating Environment, Firmware, And Software For Sun Blade 1000 And Sun Blade 2000 Workstations - Sun Microsystems Sun Blade 1000 Service Manual

8.2.1 Firmware and Software Requirements for
Installing UltraSPARC III or UltraSPARC III Cu
CPU Modules
TABLE 8-1
Solaris Operating
Environment
OpenBoot PROM
(Firmware)
Software Patches
1. Minimum level of Solaris, OpenBoot PROM, and software patches necessary ensure proper operation of the
Sun Blade 1000 and Sun Blade 2000 workstations. Always check the Sun web site for the latest compatible op-
erating environment, firmware, and software updates.
8.2.2

Removing a CPU Module

Perform the following procedures to remove an existing UltraSPARC III or an
UltraSPARC III Cu CPU module.
1. Power off the workstation.
See Section 5.5, "Powering Off the Workstation" on page 5-5.
2. Remove the access panel
See Section 5.6, "Removing the Access Panel" on page 5-8.
3. If necessary, place the workstation on its side on a work surface, open side face
up.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
8-6 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Required Solaris Operating Environment, Firmware, and Software for Sun
Blade 1000 and Sun Blade 2000 Workstations
UltraSPARC III Modules
600, 750, or 900 MHz
Sun Blade 1000
Solaris 8 10/00*
v4.4.6
109888-10
110460-09
1008528-10
1
1
1
1
UltraSPARC III Cu Modules
Sun Blade 2000
1
Solaris 8 10/01
1
v4.5.0
1
111292-05