Replacing The Diskette Drive Cable Assembly; Figure 6-8 Removing And Replacing The Diskette Drive Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

FIGURE 6-8
6.3.6

Replacing the Diskette Drive Cable Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the diskette drive cable assembly in the chassis (
2. Connect the diskette drive cable assembly as follows (
a. Connect the diskette drive cable assembly to the motherboard diskette drive
connector J1801.
b. Feed the diskette drive cable through the chassis cutout.
c. Feed the SCSI cable through the chassis cutout.
6-12 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
From diskette drive
assembly rear
connector
Removing and Replacing the Diskette Drive Cable Assembly
To motherboard connector
J1801
Cable route
FIGURE 6-8
):
FIGURE 6-8
).