Removing the Access Panel
Note – If the power cord is connected, removal of the access panel activates the
workstation power interlock circuit. This safety mechanism prevents all DC voltages
(except +5 VDC standby power) from reaching any internal components.
1. Press down on the two depressions at the top of the access panel (
2. Tilt the top of the access panel about an inch (1.5 cm) away from the chassis.
3. Lift the access panel up.
4. Lift the access panel off.
Sun Blade 1000 and Sun Blade 2000 UltraSPARC III Cu CPU Module Installation Guide
).
FIGURE 4
9