Replacing An Ultrasparc Iii Cpu Module; Table 8-2 Cpu Module Handling Procedures - Sun Microsystems Sun Blade 1000 Service Manual

8.2.3

Replacing an UltraSPARC III CPU Module

Caution – Perform the procedures described in
CPU module from its packing carton.
TABLE 8-2
Step
1
2
3
4
5
8-12 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
CPU Module Handling Procedures
Description
Use proper ESD grounding techniques when handling components.
Wear an antistatic wrist strap and use an antistatic mat. Store ESD-
sensitive components in antistatic bags before placing them on any
surface.
When you remove a CPU module from its packing carton, use both
hands to support the module along its sides.
As you remove the CPU module from its antistatic bag, handle it only by
its captive screws. Do not touch the connectors on the bottom edge of
the module. The connectors for the module are easily bent or damaged
by improper handling.
Do not remove the plastic cover from the CPU module connectors until
you are ready to install the module into the workstation motherboard.
Do not grip the CPU module by its heat sink.
when unpacking a new
TABLE 8-2