Figure 6-1 Power Supply Cable Tie - Sun Microsystems Sun Blade 1000 Service Manual

2. Squeeze the connectors to disengage them from the motherboard. Now,
disconnect the two power supply assembly connectors, J3601 and J3603, from the
motherboard (
3. Loosen the reusable cable tie in the upper-right corner of the chassis cutout that
secures the two power supply cables. (
FIGURE 6-1
4. Using a No. 2 Phillips screwdriver, remove the six screws securing the power
supply assembly to the chassis back panel (
5. Remove the power supply from the chassis by pulling on the power supply
assembly handle.
Push the power supply cable connectors through the chassis cutout while slowly
pulling the power supply out.
Note – Support the power supply assembly with one hand as you remove it from
the chassis.
6-2 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
).
FIGURE 6-2
Power Supply Cable Tie
)
FIGURE 6-1
).
FIGURE 6-3