Speaker Assembly; Removing The Speaker Assembly - Sun Microsystems Sun Blade 1000 Service Manual

5. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 5.
6.7

Speaker Assembly

Use the following procedures to remove and replace the speaker assembly.
6.7.1

Removing the Speaker Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Using a No. 2 Phillips screwdriver, remove the screw securing the speaker
assembly to the chassis (
3. Disconnect the combined cable assembly connectors from the speaker assembly
terminators.
4. Remove the speaker assembly.
).
FIGURE 6-15
Chapter 6 Removing and Replacing Major Subassemblies 6-25