Chassis Foot; Removing A Chassis Foot - Sun Microsystems Sun Blade 1000 Service Manual

3. Connect the FC-AL backplane cable assembly to the FC-AL backplane.
4. Connect the power connector to the FC-AL backplane assembly.
5. Replace the hard drive(s).
See Section 7.1.2, "Replacing a Hard Drive" on page 7-3.
6. Return the torque tool to the slot in the backplane assembly.
7. Replace the fan bracket.
See Section 6.6.2, "Replacing the Fan Bracket" on page 6-24.
8. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6.9

Chassis Foot

Use the following procedures to remove and replace a chassis foot.
6.9.1

Removing a Chassis Foot

Use a flat-tipped tool to pry the foot from the chassis (
Chapter 6 Removing and Replacing Major Subassemblies
).
FIGURE 6-17
6-29