Removing The Dvd-Rom Drive Or Any Optional Tape Drive Component - Sun Microsystems Sun Blade 1000 Service Manual

7.2.2 Removing the DVD-ROM Drive or Any Optional
Tape Drive Component
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the peripheral assembly on a flat surface so that the DVD-ROM drive or
tape drive is flat (
2. Using a No. 2 Phillips screwdriver, remove the four screws securing the DVD-
ROM drive or tape drive to the peripheral assembly.
Note – The four screws that secure a drive to the peripheral drive assembly are
specifically sized screws. Do not intermingle them with other screws.
3. Remove the DVD-ROM drive or tape drive and place it on an antistatic mat.
4. Install the filler panel if necessary.
FIGURE 7-3
).
FIGURE 7-3
Screw (4)
Removing and Replacing the DVD-ROM Drive
DVD-ROM drive
Chapter 7 Removing and Replacing Storage Devices
Filler panel
7-5