Replacing The Dvd-Rom Drive Or Any Optional Tape Drive Component; Logically Removing The Smart Card Reader - Sun Microsystems Sun Blade 1000 Service Manual

7.2.3 Replacing the DVD-ROM Drive or Any Optional
Tape Drive Component
Note – If you are installing a DVD-ROM drive or any optional tape drive
component (instead of replacing it), ensure that the peripheral power cable and all
data cables are properly routed through the clips adjacent to the peripheral
assembly. Route the SCSI cable through the clip affixed on the rear wall of the
peripheral assembly.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Remove the filler panel if necessary (see
2. Position the DVD-ROM drive or tape drive into the peripheral assembly.
3. Using a No. 2 Phillips screwdriver, replace the four screws securing the DVD-
ROM drive or tape drive to the peripheral assembly.
4. Replace the peripheral assembly.
See Section 7.2.10, "Replacing the Peripheral Assembly" on page 7-10.
7.2.4

Logically Removing the Smart Card Reader

You may need or want to logically remove a smart card reader from the workstation.
For example when a user no longer needs or wants to use a smart card for
authentication. To logically remove the smart card reader:
1. Log in as root to the workstation.
2. Logically remove the smart card reader by typing:
# smartcard -c admin -t terminal -r user_friendly_name -x delete
3. Disconnect connector J3604.
7-6 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
).
FIGURE 7-3