Replacing The Fc-Al Backplane Assembly; Figure 6-16 Removing And Replacing The Fc-Al Backplane Assembly - Sun Microsystems Sun Blade 1000 Service Manual

FC-AL backplane
assembly
FIGURE 6-16
6.8.2

Replacing the FC-AL Backplane Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the FC-AL backplane assembly in the chassis and connect it to the chassis
cutouts (
2. Using a No. 2 Phillips screwdriver, proceed as follows:
a. Replace the two screws into the chassis bottom that secure the FC-AL
backplane assembly to the chassis.
b. Tighten the two captive screws (located on the left side of the FC-AL backplane
assembly).
6-28 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Removing and Replacing the FC-AL Backplane Assembly
).
FIGURE 6-16
Captive screw (2)
Screws (2)