Removing The Logo Led Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

a. Attach the combined cable assembly connectors to the interlock switch
terminators.
b. Attach the combined cable assembly connectors to the power switch
terminators.
c. Replace the LED in the front panel LED holder.
d. Replace the combined cable assembly connectors to the speaker assembly
terminators.
e. Connect the combined cable assembly connector to motherboard connector
J3602.
3. Replace the fan bracket.
See Section 6.6.2, "Replacing the Fan Bracket" on page 6-24.
4. Replace the CPU shroud cover.
See Section 8.9.2, "Replacing the CPU Shroud" on page 8-41.
5. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6.3.11

Removing the Logo LED Cable Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Remove the CPU shroud cover.
See Section 8.9.1, "Removing the CPU Shroud" on page 8-40.
3. Remove the fan bracket.
See Section 6.6.1, "Removing the Fan Bracket" on page 6-23.
4. Disconnect the logo LED cable assembly as follows (
a. Remove the logo LEDs from the front panel.
Chapter 6 Removing and Replacing Major Subassemblies
):
FIGURE 6-11
6-17