Removing The Smart Card Reader Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

d. Connect the diskette drive cable assembly to the rear of the diskette drive.
e. Connect the SCSI cable to J5002.
3. Detach the antistatic wrist strap, replace the access panel, and power on the
workstation.
See Chapter 9.
6.3.7

Removing the Smart Card Reader Cable Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
2. Disconnect the smart card reader cable assembly from the smart card reader
(
FIGURE 6-9
3. Disconnect the smart card reader cable assembly from the motherboard connector
J3904.
4. Remove the smart card reader cable assembly from the workstation.
).
Chapter 6 Removing and Replacing Major Subassemblies 6-13