Figure 8-9 Lowering The Cpu Module Into The Threaded Inserts - Sun Microsystems Sun Blade 1000 Service Manual

CPU module
FIGURE 8-9
3. Tighten both captive screws by hand until the screws contact the threaded inserts of the
CPU shroud.
Once the CPU module is seated, surface contact between the captive screws and the
threaded inserts of the shroud typically occurs in less than one turn of both left and right
captive screws.
4. Do one of the following:
a. If you have torque tool A, perform Steps 10-15.
b. If you have torque tool B, perform Steps 5-9 and 14-15.
5. Use torque tool B to rotate the left captive screw one turn clockwise (see
Caution – Do not use a torque tool from another Sun product. The Sun Blade torque tools
are specifically designed for this workstation.
8-14 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
1
Lowering the CPU Module Into the Threaded Inserts
Captive
screw (2)
2
Threaded
inserts (2)
).
FIGURE 8-10