Removing The Combined Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

6.3.9

Removing the Combined Cable Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Remove any PCI cards necessary to gain access to the combined cable assembly.
See Section 8.3.1, "Removing a PCI Card" on page 8-20.
3. Remove the CPU shroud cover.
4. Remove the fan bracket.
See Section 6.6.1, "Removing the Fan Bracket" on page 6-23.
5. Disconnect the combined cable assembly as follows (
a. Remove the combined cable assembly connectors from the interlock switch
terminators.
b. Remove the combined cable assembly connectors from the power switch
terminators.
c. Remove the combined cable assembly connectors from the speaker assembly
terminators.
d. Remove the combined cable assembly connector from J3602 on the
motherboard.
6. Remove the LED from the chassis and lift the combined cable assembly up and
out from chassis.
Chapter 6 Removing and Replacing Major Subassemblies
):
FIGURE 6-10
6-15