Replacing The Smart Card Reader; Figure 7-4 Removing And Replacing The Smart Card Reader - Sun Microsystems Sun Blade 1000 Service Manual

FIGURE 7-4
7.2.7

Replacing the Smart Card Reader

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Remove the filler panel if necessary
2. Replace the diskette drive if it has been removed.
See Section 7.2.9, "Replacing the Diskette Drive" on page 7-10.
3. Position the smart card reader into the peripheral assembly.
4. Using a No. 2 Phillips screwdriver, replace the four screws securing the smart card
reader to the peripheral assembly.
5. Replace the peripheral assembly.
See Section 7.2.10, "Replacing the Peripheral Assembly" on page 7-10.
7-8 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Removing and Replacing the Smart Card Reader
Screw (4)
Filler panel
Smart card reader
(see ) .
FIGURE 7-3