Audio Module Assembly; Removing The Audio Module Assembly - Sun Microsystems Sun Blade 1000 Service Manual

8.5

Audio Module Assembly

Perform the following procedures to remove and replace the audio module
assembly. If necessary, view the ShowMe How video clip located on the Sun Blade
1000 and Sun Blade 2000 CD-ROM.
8.5.1

Removing the Audio Module Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
2. Lay the workstation on its side.
3. Disconnect any external audio cables from the audio module assembly.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
4. Using a No. 2 Phillips screwdriver, remove the screw securing the audio module
assembly bracket tab to the workstation chassis (
Caution – Avoid damaging the connector by not applying force to one end or one
side of the module.
5. At the two upper corners of the audio module assembly, pull the module straight
up from the connector.
6. Remove the audio module assembly.
7. Place the audio module assembly on an antistatic mat.
8-28 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
).
FIGURE 8-18