Figure 8-10 Alternately Rotating Left And Right Captive Screws One Turn Clockwise - Sun Microsystems Sun Blade 1000 Service Manual

6. Use torque tool B to rotate the right captive screw one turn clockwise (see
).
FIGURE 8-10
Torque tool B
Left captive
screw
Alternately Rotating Left and Right Captive Screws One Turn Clockwise
FIGURE 8-10
Caution – Under torquing the captive screws for the CPU module may cause a loss
of contact between the CPU module and the motherboard connector. This may cause
failure of the workstation to boot. Over torquing the captive screws for the CPU
module may cause severe damage to the module and a potential workstation failure.
7. Repeat Step 5 and Step 6 until the gap for torque tool B is 0.0 inches (0.0 mm) (see
).
FIGURE 8-11
Use the torque tool to alternately tighten the left and right captive screws to the
correct torque. Always rotate the left captive screw one turn clockwise and then
rotate the right captive screw one turn clockwise. This assures that a uniform and
even torque is applied to the CPU module.
Chapter 8 Removing and Replacing the Motherboard and Associated Components
Right captive
screw
8-15