Post Progress And Error Reporting - Sun Microsystems Sun Blade 1000 Service Manual

CODE EXAMPLE 3-4
{0}Verify no branching
{0}Testing Branching on fcc3
{0}Verify branching
{0}Verify no branching
{0}* Ecache Functional
{0}Verify cacheline fill on read miss
{0}Verify write allocate on write miss
{0}Verify cacheline update on write hit
{0}Verify write back
{0}POST_END
3.4.3

POST Progress and Error Reporting

In most cases, POST also attempts to send a failure message to the POST monitoring
system. The following code example identifies the typical appearance of a failure
message.
Note – The workstation does not automatically boot if a POST error occurs. The
workstation halts at the ok prompt to alert the user to a failure.
CODE EXAMPLE 3-5
{0}ERROR: TEST = * Memory marching Initial area TESTID = 68
{0}H/W under test = MAIN MEMORY
{0}
{0}
{0}
{0}
{0}
{0}
{0}
{0}
3-50 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
diag-level Variable Set to min (Single CPU) (Continued) (8 of 8)
POST Error Message
Fault address 00000000.00000090
Fault status 00000002.0000004f
(CE) Correctable system data ECC error
CPU data bit 6
Memory data bit 146
DIMM connector J0406
Connector pin 124
CPMS Slice 1