Replacing The Logo Led Cable Assembly; Figure 6-11 Removing And Replacing The Logo Led Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

b. Remove the logo LED cable assembly connector from J3605 on the
motherboard.
5. Remove the logo LED cable assembly from the chassis.
FIGURE 6-11
6.3.12

Replacing the Logo LED Cable Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the logo LED cable assembly in the chassis (
2. Connect the logo LED cable assembly as follows:
a. Replace the LEDs in the front panel LED holders.
b. Connect the logo LED cable assembly connector to motherboard connector
J3605.
3. Replace the fan bracket.
See Section 6.6.2, "Replacing the Fan Bracket" on page 6-24.
6-18 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
To motherboard connector J3605
Removing and Replacing the Logo LED Cable Assembly
Cable route
).
FIGURE 6-11