Figure 8-7 Using Torque Tool B To Remove A Cpu Module - Sun Microsystems Sun Blade 1000 Service Manual

Torque tool B
Right captive screw
Left captive screw
Using Torque Tool B to Remove a CPU Module
FIGURE 8-7
Caution – As you remove the CPU module from the shroud, handle it only by its
captive screws. Do not touch the connectors on the bottom edge of the module or the
electrical components on the module. The connectors and the components for the
module are easily bent or damaged by improper handling and by electrostatic
discharge (see ).
FIGURE 8-8
c. Use both hands to lift the out of the shroud.
d. Place the CPU module on an antistatic mat with the heat sink on the top facing
up.
10. If necessary, proceed to Section 8.2.3, "Replacing an UltraSPARC III CPU Module"
on page 8-12.
Chapter 8 Removing and Replacing the Motherboard and Associated Components 8-11