Powering On The Workstation - Sun Microsystems Sun Blade 1000 Service Manual

9.2

Powering On the Workstation

Perform the following procedure to power on the workstation. If necessary, view the
ShowMe How video clip located on the Sun Blade 1000 and Sun Blade 2000
Hardware Documentation CD-ROM.
Note – If it is necessary to power off the workstation, see Chapter 5.
Power on the workstation as follows:
1. Turn on power to the monitor and to all external devices.
Caution – Once the power for the workstation is switched on, the internal boot
process will begin. To prevent hardware failures, do not immediately power off the
workstation. Wait until the boot process is complete before powering off the
workstation.
2. Press the power switch on the front panel and release it (
3. After several seconds, verify that the Sun logo on the workstation front panel
energizes immediately, verify that the power indicator LED on the power switch is
energized, and listen to verify that the workstation fans are spinning.
Note – The power indicator LED on the power switch will energize after the
workstation begins the internal boot process.
9-4 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
).
FIGURE 9-3