5.6
Removing the Access Panel
To remove the access panel (
Note – Removing the access panel activates the workstation power interlock circuit.
If the power cord is connected, this safety mechanism prevents all DC voltages
(except 5 VDC standby power) from reaching any internal components when the
access panel is removed.
1. Press down on the two depressions at the top of the access panel (see
2. Tilt the top of the access panel about an inch away from the chassis.
3. Lift the access panel up.
4. Lift the access panel off.
5-8
Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
):
FIGURE 5-3
)
FIGURE 5-3