Disabling The Smart Card; Removing The Smart Card Reader - Sun Microsystems Sun Blade 1000 Service Manual

7.2.5

Disabling the Smart Card

The following procedure assumes that the user has forgotten the smart card PIN and
cannot log in to the workstation.
1. Halt the workstation and then reboot in the single user mode.
2. Disable the smart card by typing:
# smartcard -c disable
3. Exit single-user mode, and resume the workstation boot process to return to the
desktop environment.
7.2.6

Removing the Smart Card Reader

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the peripheral assembly on a flat surface so that the smart card reader is
flat (see
2. Using a No. 2 Phillips screwdriver, remove the four screws securing the smart card
reader to the peripheral assembly.
3. Remove the smart card reader and place it on an antistatic mat.
Note – The four screws that secure a drive to the peripheral drive assembly are
specifically sized screws. Do not intermingle them with other screws.
4. Install the filler panel, if necessary.
).
FIGURE 7-4
Chapter 7 Removing and Replacing Storage Devices 7-7