Replacing The Peripheral Power Cable Assembly; Figure 6-6 Removing And Replacing The Peripheral Power Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

a. Disconnect the peripheral power cable assembly connector from the
motherboard connector J3608.
b. Disconnect the peripheral power cable assembly connectors from the tape
drive, DVD-ROM drive, diskette drive, and the FC-AL backplane assembly.
5. Lift the peripheral power cable assembly up and out of the chassis.
From FC-AL
backplane assembly
FIGURE 6-6
6.3.2

Replacing the Peripheral Power Cable Assembly

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
1. Position the peripheral cable assembly in the chassis (
2. Connect the peripheral power cable assembly as follows (
6-8 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
From diskette drive
Removing and Replacing the Peripheral Power Cable Assembly
From tape or DVD-ROM drive
From motherboard
connector J3608
J3608
FIGURE 6-6
J3608
Cable route
).
):
FIGURE 6-6