Diskette Drive; Hard Drives; Table C-5 Internal Hard Drive Features - Sun Microsystems Sun Blade 1000 Service Manual

Note – The DVD-ROM drive is factory set to SCSI target ID 6. Refer to the
installation documentation for the DVD-ROM to change the target ID address.
C.1.9.2

Diskette Drive

The workstation has a standard 1.44-Mbyte diskette drive that is 1 inch (25.40 mm)
high. Refer to the Manual Eject Diskette Drive Specifications, part number 805-1133, for
diskette information, panel descriptions, and drive specifications.
Note – The diskette drive is factory-set to target address 0. Refer to the Manual Eject
Diskette Drive Specifications, part number 805-1133, to change the target address.
SuperI/O Diskette Drive Interface
The SuperI/O ASIC contains an on-board diskette drive controller with a 16-byte
first-in-first-out (FIFO) memory buffers that support burst and non-burst modes. The
diskette drive controller handles data rates of 500 Kbps and 250 Kbps. See
Section C.1.12, "Diskette Drive and Parallel Ports" on page C-32 for details.
C.1.9.3

Hard Drives

The workstation supports two internal FC-AL hard drives. Each hard drive has a
single connector configuration. A drive bracket is used to mount the drives. The
following table lists the hard drive features of some of the Sun Blade 1000 and Sun
Blade 2000 drives.
TABLE C-5
Form Factor
Dimension
1.00-inch
(2.54-cm)
1.00 inch
(2.54 cm)
1.00 inch
(2.54 cm)
C-30 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
Internal Hard Drive Features
Hard Drive Capacity
18 Gbytes
36 GBytes
73 GBytes
Seek Time (read/write)
RPM (average)
10K 7.5 msec / 8.5 msec
10K 7.5 msec / 8.5 msec
10K 7.5 msec / 8.5 msec