Sunvts Requirements; Sunvts References - Sun Microsystems Sun Blade 1000 Service Manual

SunVTS executes multiple diagnostic tests from one graphical user interface (GUI)
that provides test configuration and status monitoring. The user interface can run in
the CDE or OPEN LOOK environments or through a TTY-mode interface for
situations when running a GUI is not possible.
The SunVTS interface can run on one workstation to display the SunVTS test session
of another workstation on the network.
SunVTS is distributed with each SPARC™ or Solaris™ release. It is located on the Sun
Computer Systems Supplement CD.
2.1.1

SunVTS Requirements

Your workstation must meet the following requirements to run SunVTS:
The SunVTS packages must be installed. The main package is SUNWvts. There are
additional supporting packages that differ based on the revision of the Solaris
operating environment that is installed. For specific details, refer to the
corresponding SunVTS documentation.
The workstation must be booted to the multiuser level (level 3).
To run SunVTS with a GUI, that GUI must be installed. Otherwise, run SunVTS
with the TTY-mode interface.
2.1.2

SunVTS References

To find out more information about using SunVTS, refer to the SunVTS
documentation that corresponds to the Solaris release that you are running.
The SunVTS documents are part of the Solaris on Sun Hardware AnswerBook
collection. This AnswerBook collection is pre installed on the hard disk of new
systems. It is also distributed on the Software Supplement CD that is part of each
Solaris Media Kit release and is also accessible at http://docs.sun.com.
The following list describes the contents of each SunVTS document:
SunVTS User's Guide describes how to install, configure, and run the SunVTS
diagnostic software.
SunVTS Quick Reference Card provides an overview of how to use the SunVTS
CDE interface.
SunVTS Test Reference Manual provides details about each individual SunVTS test.
2-2 Sun Blade 1000 and Sun Blade 2000 Service Manual • January 2002
TM