Removing The Diskette Drive Cable Assembly - Sun Microsystems Sun Blade 1000 Service Manual

6.3.5

Removing the Diskette Drive Cable Assembly

1. Power off the workstation, remove the access panel, and attach the antistatic wrist
strap.
See Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. Disconnect the SCSI cable assembly at the motherboard connector J5002.
3. Disconnect the diskette drive cable assembly as follows (
a. Disconnect the diskette drive cable assembly from the motherboard diskette
drive connector J1801.
b. Disconnect the diskette drive cable assembly from the rear of the diskette
drive.
4. Feed the SCSI and diskette drive cables through the chassis cutout.
5. Remove the diskette drive cable assembly.
Chapter 6 Removing and Replacing Major Subassemblies
):
FIGURE 6-8
6-11