Printing Of Original Data; Software; Originals - Riso CV1200W User Manual

Printing of original data

You can connect this printer with the computer using a
USB cable to print the original data.
A commercially available USB cable is required for
connection. Use a cable of 2 m (6.6 feet) or shorter
that conforms to the USB 2.0 standard.
BWhen connecting using a USB cable, be
sure that the power for this machine
and the computer is turned on.
BIf you use a USB hub, the machine may
not work properly.
BThe maximum allowable voltage for
USB connector input and output is 5V.

Software

The software included in the CD-ROM provided for
this machine is as follows:
■ RISO Printer Driver
This is a dedicated printer driver that enables printing
an original from a computer.
It is necessary to install the printer driver for the first
time before the initial printing run.
For more information, see the user's guide (PDF file)
included in the CD-ROM.

Originals

■ Size and weight
The following sizes and weights of originals are
usable:
Size 90 mm × 140 mm to 310 mm × 435 mm
(3 17/32 inches × 5 1/2 inches to
12 7/32 inches × 17 1/8 inches)
2
Weight 50 g/m to 107 g/m
(13-lb bond to 29-lb bond)
• Do not mix originals of different sizes for the docu-
ment feeder.
BYou cannot use the following originals for
this machine.
CMulti-layered originals
COriginal with staples or clips
CPatched original
CExcessively wrinkled, curled, or creased
original
COriginal with sticky areas or holes
CTorn original or deckle-edged original
CChemically treated original (such as
thermal or carbon paper)
CTransparent original (such as OHP films
or tracing paper)
COriginal with correction fluid or glue
CExtremely thin original (less than
2
50 g/m [13-lb bond])
CExtremely thick original (greater than
2
107 g/m [29-lb bond])
COriginal with slippery surface (such as
art or coated paper)
• If ink or correction fluid is used on an original, thor-
oughly dry it before placement. Failure to do so may
contaminate the document feeder, and this impairs
proper printing.
■ Direction of original
The leading edge of an original in the feeding direction
is referred to as the "top".
2
11