Console Port Connector Pinout Information; Usb Port Specifications For An Ex Series Switch - Juniper EX8208 Hardware Manual

Console Port Connector Pinout Information

The console port on a Juniper Networks device is an RS-232 serial interface that uses an RJ-45 connector
to connect to a console management device. The default baud rate for the console port is 9600 baud.
Table 63 on page 136 provides the pinout information for the RJ-45 console connector.
NOTE: If your laptop or desktop PC does not have a DB-9 plug connector pin and you want to
connect your laptop or desktop PC directly to a device, use a combination of the RJ-45 to DB-9
socket adapter and a USB to DB-9 plug adapter. You must provide the USB to DB-9 plug adapter.
Table 63: Console Port Connector Pinout Information
Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
5 Signal Ground
6 RxD Input
7 CD Input
8 NC

USB Port Specifications for an EX Series Switch

The following Juniper Networks USB flash drives have been tested and are officially supported for the
USB port on all EX Series switches:
RE-USB-1G-S
RE-USB-2G-S
RE-USB-4G-S
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
CTS Input
136