Unpacking And Mounting The Ex8208 Switch; Unpacking An Ex8200 Switch - Juniper EX8208 Hardware Manual

Unpacking and Mounting the EX8208 Switch

IN THIS SECTION

Unpacking an EX8200 Switch | 140

Unpacking a Line Card Used in an EX8200 Switch | 143
Parts Inventory (Packing List) for an EX8208 Switch | 144
Register Products—Mandatory to Validate SLAs | 147
Installing and Connecting an EX8208 Switch | 147
Installing Adjustable Mounting Brackets in a Rack or Cabinet for an EX8200 Switch | 148
Installing the Power Cord Tray in a Rack or Cabinet for an EX8200 Switch | 151
Mounting an EX8208 Switch on a Rack or Cabinet | 154
Mounting an EX8208 Switch on a Rack or Cabinet Using a Mechanical Lift | 157
Mounting an EX8208 Switch on a Rack or Cabinet Without Using a Mechanical Lift | 159
Unpacking an EX8200 Switch
After you prepare the installation site as described in
on page 108, you may unpack the switch.
NOTE: The switch is maximally protected inside the shipping box. Do not unpack it until you
are ready to begin installation.
Ensure that you have the following parts and tools available to unpack the EX8200 switch:
A 7/16-in. or 11-mm open-end or socket wrench to remove the bracket bolts from the shipping pallet
A box cutter or packing knife to slice open the tape that seals the top of the box
The switch ships in a cardboard box that has a two-layer wooden pallet base with foam cushioning between
the layers. The switch chassis is bolted to the pallet base.
The EX8208 chassis ships with the Switch Fabric and Routing Engine (SRE) module(s), Switch Fabric (SF)
module, fan tray, and power supplies for the configuration you ordered already installed. Any line cards
ordered ship separately.
"Site Preparation Checklist for an EX8200 Switch"
140