Line Card Components; Line Card Ports - Juniper EX8208 Hardware Manual

Table 41: EX8200-2XS-40P Line Card Models
Model Description
EX8200-2XS-40P 40-port PoE+ with
4-port SFP and 2-port
SFP+ line card

Line Card Components

The EX8200-2XS-40P line card (see
40 oversubscribed RJ-45 ports (PoE-enabled or PoE+-enabled)
4 SFP uplink ports
2 SFP+ uplink ports
Six dust covers (shipped in an accessory bag)
Line card status LEDs—Three status LEDs labeled ON, ST, and PoE that indicate the online, status, and
Power over Ethernet (PoE) information for the line card. See
page 105.
Network port LEDs—Two LEDs per network port that indicate the link/activity and status of each port.
See Network Port LEDs in an EX8200 Switch.

Line Card Ports

Table 42 on page 93 shows the port number, port type, and port throughput on an EX8200-2XS-40P line
card.
Table 42: Ports on the EX8200-2XS-40P Line Card
Port Number Port Type
0 through 11 Oversubscribed, RJ-45,
PoE+ enabled
12 through 39 Oversubscribed, RJ-45,
PoE enabled
40 through 43 SFP
Junos OS Support on
Release EX8200 Virtual
Required Chassis
11.2R1 or later 11.4R1
Figure 23 on page 92) has:
Throughput Additional Information
10/100/1000 The first 12 RJ-45 ports (ports 0–11) are PoE+
Gigabit Ethernet enabled and support IEEE 802.3at.
10/100/1000 The final 28 RJ-45 ports (ports 12–39) are PoE
Gigabit Ethernet enabled and support IEEE 802.3af.
Line rate Can be used as an uplink of 1-Gigabit Ethernet fiber
links in a link aggregation group (LAG).
EX8200 Virtual Chassis
Port (VCP) Support
11.4R1
NOTE: VCPs supported on
SFP+ transceivers only
"Line Card LEDs in an EX8200 Switch" on
93