Removing A Line Card From An Ex8200 Switch - Juniper EX8208 Hardware Manual

Ensure that you know how to handle and store the line card (see Handling and Storing Line Cards in EX6200
and EX8200 Switches).
To unpack a line card (see
1. Move the shipping carton to a staging area as close to the installation site as possible.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Pull out the packing material, which holds the line card in place.
5. Remove the line card from the antistatic bag.
6. Save the shipping carton and packing materials in case you need to move or ship the line card later.
Figure 81: Unpacking a Line Card Used in an EX8200 Switch
SEE ALSO
Packing a Line Card Used in an EX8200 Switch | 344

Removing a Line Card from an EX8200 Switch

EX8200 switches have field-replaceable unit (FRU) line cards that can be installed in the line card slots on
the front of the switch chassis. The line cards are hot-insertable and hot-removable: You can remove and
replace them without powering off the switch or disrupting switch functions.
Before you begin removing a line card from an EX8200 switch:
Figure 36 on page 144):
268