Line Card Components; Line Card Ports - Juniper EX8208 Hardware Manual

Table 45: EX8200-48PL Line Card Models
Model Description
EX8200-48PL 48-port PoE+ 20
Gbps line card

Line Card Components

The EX8200-48PL line card (see
48 oversubscribed RJ-45 ports (PoE-enabled or PoE+-enabled)
Line card status LEDs—Three status LEDs labeled ON, ST, and Power over Ethernet (PoE) that indicate
the online, status, and PoE information for the line card. See
page 105.
Network port LEDs—Two LEDS per network port that indicate the link/activity and status of each port.
See Network Port LEDs in an EX8200 Switch.

Line Card Ports

Table 46 on page 98 shows the port number, port type, and port throughput on an EX8200-48PL line
card.
Table 46: Ports on the EX8200-48PL Line Card
Port Number Port Type
0 through 11 Oversubscribed,
RJ-45,
PoE+-enabled
12 through 47 Oversubscribed,
RJ-45,
PoE-enabled
The ports are divided into two port groups:
The ports 0 through 23 form one port group.
The ports 24 through 47 form another port group.
Junos OS Release
Required
11.2R1 or later
Figure 25 on page 97) has:
Throughput
10/100/1000
Gigabit Ethernet
10/100/1000
Gigabit Ethernet
Support on EX8200
Virtual Chassis
11.4R1
"Line Card LEDs in an EX8200 Switch" on
Additional Information
The first 12 RJ-45 ports (ports 0–11) are PoE+-enabled
(support IEEE 802.3at)
The final 36 RJ-45 ports (ports 12–47) are PoE-enabled
(support IEEE 802.3af)
EX8200 Virtual Chassis
Port (VCP) Support
Not supported
98