Console Port Connector Pinout Information For An Ex Series Switch; Switch; Component Specifications; Table 16: Ex Series Switches Console Port Connector Pinout Information - Juniper EX3200 Series Complete Hardware Manual

Table 15: Network Port Connector Pinout Information for an EX3200 or EX4200
Switch (continued)
Pin
7
8
Related Topics

Console Port Connector Pinout Information for an EX Series Switch

Table 16: EX Series Switches Console Port Connector Pinout Information

Pin
1
2
3
4
5
6
7
8
Related Topics
Copyright © 2010, Juniper Networks, Inc.
Signal
TRP4+
TRP4-
Front Panel of an EX3200 Switch on page 7
Front Panel of an EX4200 Switch on page 9
The console port on an EX Series switch is an RS-232 serial interface that uses an RJ-45
connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.
Table 16 on page 41 provides the pinout information for the RJ-45 console connector.
An RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to
connect your laptop or PC directly to an EX Series switch, use a combination of the
RJ-45 to DB-9 female adapter supplied with the switch and a USB to DB-9 male adapter.
You must provide the USB to DB-9 male adapter.
Signal
RTS Output
DTR Output
TxD Output
Signal Ground
Signal Ground
RxD Input
CD Input
CTS Input
See Rear Panel of an EX2200 Switch for port location.
Chapter 3: Component Specifications
Description
Transmit/receive data pair 4
Transmit/receive data pair 4
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
41