Juniper EX8208 Hardware Manual page 221

Table 79: Chassis Viewer for EX4300 Switches (continued)
Field
PIC 2 slot
NOTE: In EX4300 switches the LEDs are seen in the front panel, these are not active.
Rear View of the EX4300 Switch
Management port
Console port
USB port
Fan tray
Power supplies
Description
You can install an uplink module in the PIC 2 slot. Mouse over the ports in the module to
view the details of the ports in module.
24-port and 48-port EX4300 switches support the 4-port 10-Gigabit SFP+ uplink module.
EX4300-32F switches support the 2-port 40-Gigabit QSFP+ uplink module and the 8-port
10-Gigabit SFP+ uplink module.
When you install a transceiver in the port, the following colors denote the interface status:
Green—Interface is up and operational.
Yellow—Interface is up but is not operational.
Gray—Interface is down and not operational.
The management port is used to connect the switch to a management device for out-of-band
management.
The Console port (RJ-45) is used to connect the switch to a management console or to a
console server.
Indicates the USB port for the switch.
NOTE: We recommend that you use USB flash drives purchased from Juniper Networks
for your EX Series switch.
Mouse over the fan tray icons to display name, status, and description information.
Mouse over the power supply icons to display name, status, and description information.
221