Juniper EX8208 Hardware Manual page 342

5. Replace the foam padding on top of the chassis.
6. Place the power cords in the box.
7. Remove the adjustable mounting brackets from the rack or cabinet and place them and their connecting
screws in the accessory box.
8. Place the accessory box in its slot in the foam padding. See
Switch" on page 144 or Parts Inventory (Packing List) for an EX8216 Switch to verify that you have included
all the proper contents of the accessory box.
9. Slide the cardboard box over the chassis, making sure that the arrows on the box point up and the
pallet fasteners to secure the cardboard box to the wooden pallet are near the bottom.
10. Attach the cardboard box to the wooden pallet using the four pallet fasteners attached to the pallet.
See Figure 116 on page
fastener, then slide each fastener into its corresponding slot in the cardboard box and release the ridges
to secure the latch.
Figure 116: Insert Pallet Fasteners in the Cardboard Box
11. Write the RMA number on the exterior of the box to ensure proper tracking.
342. Squeeze together the two ridges ("fins") in the depression in each pallet
"Parts Inventory (Packing List) for an EX8208
342