48-Port Rj-45 Line Card In An Ex8200 Switch - Juniper EX8208 Hardware Manual

48 1-gigabit SFP ports, which can house SFP transceivers
48 dust covers (in an accessory bag)
Line card status LEDs—Two status LEDs labeled ON and ST that indicate the online and status information
for the line card. See "Line Card LEDs in an EX8200 Switch" on page
Network port LEDs—Two LEDs per network port that indicate the link/activity and status of each port.
See Network Port LEDs in an EX8200 Switch.

48-Port RJ-45 Line Card in an EX8200 Switch

IN THIS SECTION
Line Card Models | 104
Line Card Components | 104
The line cards in EX8200 switches combine a Packet Forwarding Engine and Ethernet interfaces on a single
assembly. They are field-replaceable units (FRUs) that can be installed in the line card slots on the front
of the switch chassis. The line cards are hot-insertable and hot-removable: You can remove and replace
them without powering off the switch or disrupting switch functions (see
Figure 28: 48-port RJ-45 Line Card
NOTE: Figure 28 on page 103
version of this line card has 4-in.-long ejector levers.
RJ-45 ports
Line card
LEDs
Ejector levers
shows a line card that has 2-in.-long ejector levers. An earlier
105.
Figure 28 on page
Captive screw
103
103).