Connecting Dc Power To An Ex8200 Switch - Juniper EX8208 Hardware Manual

174
9. Insert the power cord plug into an AC power source outlet.
10. If the AC power source outlet has a power switch, set it to the ON (|) position.
11. Verify that the INPUT OK LED on the power supply faceplate is lit and is on steadily.
12. Repeat steps 2 through 11 for the remaining power supplies.
Figure 51: Connecting the Power Supply Cord to an EX8200 Switch
SEE ALSO
AC Power Supply in an EX8200 Switch | 56

Connecting DC Power to an EX8200 Switch

An EX8200 switch can be configured with up to six DC power supplies. After you have installed at least
one power supply, you can connect power to the switch.