Ac Power Supply Leds In An Ex8200 Switch - Juniper EX8208 Hardware Manual

Table 24: N+N Power Supply Requirements for EX8216 Switch Configurations Using 3000 W AC Power
Supplies (Junos OS Release 10.2 or Later Only)
Switch
Configuration Input Voltage
Base High-voltage line (200–240 VAC)
Fully loaded with High-voltage line (200–240 VAC)
8-port SFP+ line
cards

AC Power Supply LEDs in an EX8200 Switch

An AC power supply has three LEDs on its faceplate. These LEDs display information about the status of
the power supply. See Figure 12 on page
Figure 12: AC Power Supply LEDs on an EX8200 Switch
Table 25 on page 64 describes the LEDs on an AC power supply in an EX8200 switch.
Power Supplies
Needed (N)
1
3
63.
Power Supplies
Needed for N+N
Redundancy
2
6
63