40-Port Sfp+ Line Card In An Ex8200 Switch - Juniper EX8208 Hardware Manual

Eight 10-gigabit SFP+ ports, which can house SFP+ transceivers
NOTE: The 10-Gigabit Ethernet ports on the 8-port SFP+ line cards are the only ports that
you can configure as Virtual Chassis port (VCP) links between EX8200 member switches in an
EX8200 Virtual Chassis. You cannot configure ports on any other EX8200 line cards—including
the 10-Gigabit Ethernet ports on the 40-port SFP+ line cards—as VCPs. See Setting a 10-Gigabit
Ethernet Port as a Virtual Chassis Port in an EX8200 Virtual Chassis (CLI Procedure).
Eight dust covers preinstalled in the network ports
Line card status LEDs—Two status LEDs labeled ON and ST that indicate the online and status information
for the line card. See "Line Card LEDs in an EX8200 Switch" on page
Network port LEDs—Two LEDs per network port that indicate the link/activity and status of each port.
See Network Port LEDs in an EX8200 Switch.
SEE ALSO
SFP+ Direct Attach Copper Cables for EX Series Switches | 129

40-port SFP+ Line Card in an EX8200 Switch

IN THIS SECTION
Line Card Models | 89
Line Card Components | 90
Line Card Ports | 90
The line cards in EX8200 switches combine a Packet Forwarding Engine and Ethernet interfaces on a single
assembly. They are field-replaceable units (FRUs) that can be installed in the line card slots on the front
of the switch chassis. The line cards are hot-insertable and hot-removable: You can remove and replace
them without powering off the switch or disrupting switch functions. See
105.
Figure 21 on page 89.
88