Juniper EX8208 Hardware Manual page 242

8. Using both hands, place the power supply in the power supply slot on the front of the switch. Slide the
power supply straight into the chassis until the power supply is fully seated in the slot. Ensure the
power supply faceplate is flush with any adjacent power supply faceplates or power supply cover
panels.
9. Push the handle towards the faceplate of the power supply until it is flush against the faceplate.
10. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
11. Tighten the captive screw by turning it clockwise using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the switch chassis.
Figure 69: Installing an AC Power Supply in an EX8200 Switch
SEE ALSO
Calculating Power Requirements for an EX8208 Switch | 121
Calculating Power Requirements for an EX8216 Switch
AC Power Supply in an EX8200 Switch | 56
242