Rj-45 Management Port Connector Pinout Information; Console Port Connector Pinout Information; Table 37: Cable Specifications For Console And Management Connections For The Qfx Series; Table 38: Rj-45 Management Port Connector Pinout Information - Juniper QFX10002 Hardware Manual

QFX10002 Switch Hardware Guide

Table 37: Cable Specifications for Console and Management Connections for the QFX Series

Port on QFX Series
Device Cable Specification
Console port RS-232 (EIA-232) serial cable
Management port Category 5 cable or
equivalent suitable for
1000BASE-T operation

RJ-45 Management Port Connector Pinout Information

Table 38: RJ-45 Management Port Connector Pinout Information

Pin Signal
1 TRP1+
2 TRP1-
3 TRP2+
4 TRP3+
5 TRP3-
6 TRP2-
7 TRP4+
8 TRP4-

Console Port Connector Pinout Information

80
Cable Supplied
One 7-foot (2.13-meter) long
RJ-45 patch cable and RJ-45 to
DB-9 adapter
One 7-foot (2.13-meter) long
RJ-45 patch cable
Table 38 on page 80 provides the pinout information for the RJ-45 connector for the
management port on Juniper Networks devices.
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
The console port on a Juniper Networks device is an RS-232 serial interface that uses an
RJ-45 connector to connect to a console management device. The default baud rate for
the console port is 9600 baud.
Table 39 on page 81 provides the pinout information for the RJ-45 console connector.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a device, use a combination of
the RJ-45 to DB-9 female adapter and a USB to DB-9 male adapter. You
must provide the USB to DB-9 male adapter.
Device
Maximum Length Receptacle
7 feet (2.13 meters) RJ-45
328 feet RJ-45
(100 meters)
Copyright © 2019, Juniper Networks, Inc.