Juniper EX8208 Hardware Manual page 254

5. Pull both the ejector levers outwards, away from the faceplate of the SRE module, until they go no
further. This action causes the SRE module to slide out of the chassis slightly.
6. Grasp the ejector levers and pull the SRE module out to about halfway.
7. Taking care not to touch the leads, pins, or solder connections, place one hand underneath the SRE
module to support it and slide it completely out of the chassis.
8. Place the SRE module in the antistatic bag or on the antistatic mat.
9. If you are not replacing the SRE module, place the cover panel over the empty slot, insert the screws
through the holes on each side of the cover panel, and tighten the screws with the screwdriver.
Figure 75: Removing an SRE Module from an EX8208 Switch
SEE ALSO
Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch | 78
254