Connecting Ac Power To An Ex8200 Switch - Juniper EX8208 Hardware Manual

3. Attach an ESD grounding strap to your bare wrist, and connect the strap to the ESD grounding point
on the switch.
4. Place the grounding lug attached to the grounding cable over the protective earthing terminal. See
Figure 49 on page 171.
Figure 49: Connecting a Grounding Cable to an EX Series Switch
5. Secure the grounding lug to the protective earthing terminal with the washers and screws.
6. Dress the grounding cable and ensure that it does not touch or block access to other switch components
and that it does not drape where people could trip over it.
SEE ALSO
General Safety Guidelines and Warnings | 347
Grounded Equipment Warning | 365

Connecting AC Power to an EX8200 Switch

EX8200 switches can be configured with up to six AC power supplies. After you have installed at least
one power supply, you can connect power to the switch.
Grounding lug
Screw
(with split
washer)
171