Network Port Leds In An Ex8200 Switch - Juniper EX8208 Hardware Manual

SEE ALSO
Chassis Component Alarm Conditions on EX8200 Switches | 300
Understand Alarm Types and Severity Levels on EX Series Switches | 299

Network Port LEDs in an EX8200 Switch

Each network port on the faceplate of a line card has two LEDs.
port LEDs on the line cards.
Figure 7: Network Port LEDs on Line Cards
Network port LEDs:
Status Link/Activity
Link/ Status
Activity
The LEDs labeled Link/Activity in
Table 15 on page 51 describes the Link/Activity LED.
Table 15: Network Port LEDs on Line Cards in an EX8200 Switch—Link/Activity LED
LED
Link/Activity
The LEDs labeled Status in
The port parameters are administrative status, speed, duplex mode, and Power over Ethernet (PoE) status.
Table 16 on page 52 describes the Status LED. From the Idle menu of the LCD panel, use the Enter button
on the LCD panel to toggle between the ADM, SPD, DPX, and POE indicators.
Link/Activity Status
lower port lower port
Link/Activity Status
upper port upper port
Figure 7 on page 51
Color
Green
Figure 7 on page 51 indicate the status of one of the three port parameters.
Figure 7 on page 51
Link/
Activity
indicate link activity.
State and Description
On steadily—The port and the link are active, but there
is no link activity.
Blinking—The port and the link are active, and there is
link activity.
Off—The port is not active.
shows the network
Status
51