Juniper EX8208 Hardware Manual page 293

To remove the switch using a lift (see
1. Use the appropriate Phillips (+) screwdriver to remove the 24 mounting screws that attach the chassis
front-mounting brackets to the rack or cabinet.
2. Move the lift to the rack and position it so that its platform is centered about 0.5 in. (1.27 cm) below
the bottom of the switch chassis and as close to it as possible.
3. Carefully slide the switch from the adjustable mounting brackets attached to the rack onto the lift.
4. Use the lift to transport the switch to its new location.
Figure 95: Removing an EX8208 Switch Chassis Using a Mechanical Lift
Figure 95 on page 293):
293