Ex8200 Network Cable And Transceiver Planning; Pluggable Transceivers Supported On Ex8200 Switches - Juniper EX8208 Hardware Manual

Understanding Power Management on EX Series Switches

EX8200 Network Cable and Transceiver Planning

IN THIS SECTION

Pluggable Transceivers Supported on EX8200 Switches | 128

SFP+ Direct Attach Copper Cables for EX Series Switches | 129
Understanding EX Series Switches Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion | 131
Calculating the Fiber-Optic Cable Power Budget for EX Series Devices | 132
Calculating the Fiber-Optic Cable Power Margin for EX Series Devices | 133
Pluggable Transceivers Supported on EX8200 Switches
The line cards on EX8200 switches support SFP and SFP+ transceivers.
You can find the list of transceivers supported on EX8208 switches and information about those
transceivers at the Hardware Compatibility Tool page for
You can find the list of transceivers supported on EX8216 switches and information about those
transceivers at the Hardware Compatibility Tool page for
NOTE: We recommend that you use only optical transceivers and optical connectors purchased
from Juniper Networks with your Juniper Networks device.
CAUTION:
third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC)
can help you diagnose the source of the problem. Your JTAC engineer might recommend
that you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.
If you face a problem running a Juniper Networks device that uses a
EX8208.
EX8216.
128